Is your Netgear WiFi range extender not standing up to the mark? Well, there can be various reasons preventing your device from performing well: loose cable connections, outdated or corrupted firmware, an unstable connection between the WiFi devices, technical glitches, etc.
No matter what is the reason behind the poor performance of your WiFi extender, the steps mentioned in this article will surely help you troubleshoot the issue. So, keep reading.
Tips to Boost Performance of Your Netgear Extender
1. Relocate Your WiFi Extender
One of the biggest reasons why your Netgear range extender isn’t performing well is because it isn’t placed at the right location. Therefore, it is recommended that you immediately change the location of your device. Remember the following points while doing so:
- Place your Netgear extender in a well-ventilated and clean area.
- Your extender should not be placed near corners and thick concrete walls.
- Avoid placing your extender near cordless phones, washing machines, baby monitors, refrigerators, Bluetooth speakers, microwave ovens, etc.
- Also, do not keep your WiFi extender near reflexive surfaces.
2. Perform Netgear Firmware Update
Updating the firmware of your Netgear WiFi range extender can also help you enhance its overall performance. Walk through the instructions mentioned below and learn how to update the firmware of your device:
- Launch an internet browser on your PC and connect to Netgear_ext.
- Access 192.168.1.250default extender IP.
- Fill in the default username and password and click Log In.
- Head over to the Settings option and select Administration.
- Look for the Firmware Update option.
- Once found, select it, and follow the on-screen instructions.
In this manner, you’ll easily be able to update the firmware of your Netgear WiFi extender.
Note: If you can’t access 192.168.1.1, then use www.mywifiext.net to log in to your device.
3. Reboot Your Netgear Extender
Sometimes, the performance of your WiFi range extender can also go down due to technical glitches. But, not to worry! A simple restart is enough to get rid of the issue.
Mentioned below are the steps that’ll help you reboot your Netgear WiFi device:
- Disconnect every WiFi-enabled device connected to your extender.
- Power off the extender and unplug it from the wall socket.
- Wait for a couple of seconds.
- Then, plug the Netgear range extender back into the wall outlet.
- Press the Power button on your WiFi device.
4. Check the Connection Between Your WiFi Devices
Your Netgear extender also might not be functioning well because it isn’t properly connected to the router. To troubleshoot the issue, check the connection between your WiFi devices. Is it strong enough? No? Well that’s probably because the Ethernet cable connecting them is worn out. Thus, replace the cable with a new one and create a strong connection between the range extender and WiFi router.
5. Bring Your WiFi Devices Closer
Too much distance between your WiFi devices can also stop your Netgear extender from performing well. Therefore, make sure that your range extender is placed in the same room as that of the router. Doing so will ensure that your extender is properly receiving signals from the router and extending them.
6. Reset Your Netgear WiFi Extender
All technical devices are prone to issues. And, unfortunately, there comes a time when you can do nothing about them. Same is the case with your Netgear WiFi range extender. If you’ve tried every troubleshooting step mentioned in this post to boost the performance of your device, but nothing worked, then perform default factory reset.
Restoring your Netgear extender to the default factory settings will give it a fresh start. In order to reset your device, access the 192.168.1.250 extender IP.
Sum Up
Like any other technical device, a Netgear extender can also sometimes not stand up to your expectations. But, fret not! If you follow the tips mentioned in this article, there’s nothing that can stop you from enhancing the performance of your WiFi device.