In order to ensure the proper functioning of your Netgear Nighthawk router, there is a need to keep the firmware of your device up-to-date. Your router is intended to auto update its firmware. But, sometimes, Netgear Nighthawk router fails to auto update its firmware, resulting in lot of technical and poor connectivity issues.
If you are also facing this type of issue, then we suggest you refer to this troubleshooting blog. In this particular piece of writing, we have covered one of the best tips to fix “Netgear Nighthawk router fails to auto update its firmware” issue in a fly. Without much delay, let’s get started!
Guidelines to Fix Nighthawk Router Fails to Auto Update its Firmware
Go through the guidelines outlined underneath one-by-one to troubleshoot the annoying issue:
Fix 1: Power Cycle Your Netgear Nighthawk Router
To reboot or power cycle the device, do the following:
- First of all, turn off the power outlet to which your Netgear Nighthawk router is plugged in.
- Before that, don’t forget to disconnect it from all the connected devices.
- Wait for some time.
- After that, plug your Netgear Nighthawk router back in.
- Connect your router to the modem using an Ethernet cable.
Now, access the Netgear router login page and check if your Nighthawk device has started searching for the auto firmware update.
Fix 2: Relocate Your Netgear Nighthawk Router
Place your Nighthawk router and modem in close proximity. But, not too closer that their WiFi signals clash with each other. Also, ensure that your devices are receiving steady power supply from their wall outlets. Doing so will somehow ensure that your Netgear Nighthawk router is getting enough WiFi signals from your modem to perform the firmware update process.
Fix 3: Check the Wireless Connectivity
Check your internet connectivity and make sure that you have enough data pack to update the Nighthawk’s firmware. On the off chance if your data speed is slow, contact your ISP right away.
Now, try to access the routerlogin page to check your internet connectivity. Once you have enough data speed, you can try to auto update the Netgear Nighthawk router’s firmware.
The tips listed above might fix the Netgear Nighthawk router’s firmware auto-update issue. But, if the issue continues to persist, you can get the firmware of your device updated manually by following the steps mentioned below.
How to Manually Update the Firmware of Your Netgear Nighthawk Router?
- First and foremost, connect your Netgear Nighthawk router to modem. You can either use a wireless or a wired source to connect your devices.
- Power them on and ensure to provide the devices a continuous power supply. Do not plug your devices into a wall outlet that is damaged or fluctuated. Also not place the device in corners, near windows, or within the reach of public WiFi network.
- Launch an up-to-date web browser of your choice on a PC or laptop and enter the default routerlogin.net web address or 192.168.1.1 IP in the URL bar. In order to prevent any login issues, do not use the browser’s search bar. Besides, it is also suggested – clear cache, cookies, and browsing history from the internet browser. Close all the unwanted tabs as well. Doing so will somehow improve the browsing speed.
- Press Enter and you will be taken to the Netgear Nighthawk setup page.
- Fill the router login credentials into the required fields.
- Once you’re done, click Log In.
- Locate Firmware Update option and click it.
- Now follow the on-screen instructions to complete the firmware update process.
The Last Words
After following the on-screen instructions in exact given order, you will be able to update the firmware of your Netgear Nighthawk router manually. Just in case, you fail to go through the manual steps, without much delay, drop all your concerns into the comments section.