Are you unable to update the firmware of your Linksys AC1200 wireless range extender? Have you implemented every troubleshooting tip possible but failed to resolve the issue? Well, that is probably because you did not follow the correct step.
In order to get rid of the Linksys extender firmware update failure issue, you need to perform Linksys extender reset. Follow the guidelines mentioned below and learn how to restore your Linksys range extender to the factory default settings. Read on.
Different Methods to Reset Linksys AC1200 Extender
In this post, we have explained two different methods through which you can reset your Linksys AC1200 WiFi range extender:
- Via Manual Method
- Using Reset Button
You are free to use any of these two methods to restore your Linksys AC1200 extender.
Linksys AC1200 Extender Reset Using Reset Button
Mentioned below are instructions that you should go through in order to reset your Linksys AC1200 range extender via the Reset button:
- Look for the Reset button on the Linksys AC1200 range extender.
- Once found, carefully press it using an oil pin or any other sharp object.
- Wait for some time and let your device get restored to the default mode.
Note: Do not hold the Reset button for too long. Otherwise, you won’t take much time to run into technical issues.
In this manner, you will be able to reset your Linksys AC1200 using the Reset button.
Linksys AC1200 Extender Reset Via Manual Method
Another way through which you can restore your Linksys AC1200 wireless range extender to the factory default settings is using the Manual method. So, take the help of the steps given below and get to know how to reset your Linksys extender manually:
- Plug your Linksys AC1200 range extender into a power outlet and turn it on.
Note: Make sure that your Linksys wireless range extender is receiving an adequate power supply from the electrical outlet.
- Let the LED become solid green. If the LED on your Linksys AC1200 extender does not turn green, reboot your device, and try to perform factory default reset from scratch.
- Connect your extender and the existing router using a cable. You can also connect your devices using a wireless source.
Note: Ensure that the Ethernet cable connecting your Linksys AC1200 extender is not worn out or damaged from anywhere.
- Switch on your computer and open an internet browser. Make sure that it is updated.
- In the URL bar of the internet browser, type the default web address of your Linksys device.
Note: You can also use the default IP address to log in to your Linksys AC1200 wireless range extender.
- Press the Enter key.
- Once on the Linksys extender login page, enter the default username and password.
- Click Log In.
- Once you have accessed the Linksys extender setup wizard, click Settings.
- Under Maintenance, click Reset.
- When asked for confirmation, click the Yes button.
- Wait for some time and let your changes become effective.
Note: If you are not certain regarding the default username and password of your Linksys wireless range extender, it is recommended that you refer to the user manual. You will find every little detail about your AC1200 extender in there.
By following these guidelines, you will be able to restore your Linksys AC1200 wireless range extender using the Manual method.
Final Thoughts
Our guide to reset Linksys AC1200 extender has come to an end here. We hope that after taking the help of the instructions mentioned above, you will be able to restore your Linksys range extender to the factory default settings.
Once done perform Linksys extender setup from scratch. Then, try to update the firmware of your wireless device to the latest version.